Siemens SITRANS F US - 3.3 Connecting the sensor cables to the transmitter; 3.4 Mounting the cables into SITRANS FUS060 connection module

Installing/Mounting
2.2 F US Clamp-on Communications Module Installation
F US Clamp-on Communications Protocol Manual
10 Hardware Installation Manual, 11/2015, A5E34981613-AC
These Communications Module installation instructions address the three types of
installation procedures for the flowmeter:
1. Flowmeters purchased with the correct MLFB number that includes the Communications
Module will be installed by the factory and no installation of the Communications Module
is required.
2.
New Communications Module Installation.
Procedure requires installation of Communications Module with the necessary mounting
kit:
Note
Refer to page 10 for the New Communications Module Installation
procedure.
Mounting Kit
Meter Type
Meter Configuration
1015N-5M-MK1 All meter types that include
1010N-5 Analog Input module
(i.e. FUS, FUE, FUG, FUH
1010 Systems).
1010N-2 I/O Module with
1010N-5 Analog Input Module
installed
1010N-7 Expanded I/O Module
with 1010N-5 Analog Input
Module installed
1015N-5M-MK2 FUS1010N/DN without 1010N-
5 Analog Input module.
1010N-2 I/O Module only in-
stalled
1010N-7 Expanded I/O Module
only installed
3.
Field Upgrade with New Communications Module.
Required installation procedures include:
● Removal of the existing communications module
● Installation of Communications Module (no mounting kit necessary)