Appendix A
A.1 Modbus, EIP, HART & N2 Profile Mappings
F US Clamp-on Communications Protocol Manual
Hardware Installation Manual, 11/2015, A5E34981613-AC
95
Profile 16 (FUS1010-5N04-5.04.05-1-2CO)
C1 Inst.Flow
30109 4 Real Analog_In 6 Float 129 6-06h T ADF(Float) 1 1
C1 Flow Rate
Units
30517 8 String String_In 4 UINT16 131 6-06h BD(Byte) 9 8
C2 Inst.Flow
30111 4 Real Analog_In 7 Float 129 7-07h Q ADF(Float) 2 1
C2 Flow Rate
30521 8 String String_In 8 UINT16 131 7-07h BD(Byte) 17 8
C3 Inst.Flow
30113 4 Real Analog_In 8 Float 129 8-08h ADF(Float) 3 1
C3 Avg Flow
30125 4 Real Analog_In 9 Float 129 3-03h P ADF(Float) 4 1
C3 Flow Rate
30525 8 String String_In 12 UINT16 131 3-03h BD(Byte) 25 8
C1 Status
/Alarms: Spacing
10021 1 Bit Coil Binary_In 0 UINT16 n/a DI(Dig In) 1 1
C1 Status
10022 1 Bit Coil Binary_In 0 UINT16 n/a DI(Dig In) 3 1
C1 Status
10023 1 Bit Coil Binary_In 0 UINT16 n/a DI(Dig In) 4 1
C1 Status
10024 1 Bit Coil Binary_In 0 UINT16 n/a DI(Dig In) 5 1
C1 Status
10025 1 Bit Coil Binary_In 0 UINT16 n/a DI(Dig In) 6 1
C1 Status
10026 1 Bit Coil Binary_In 0 UINT16 n/a DI(Dig In) 7 1