Siemens SITRANS F US - A Appendix A; Introduction; Modbus, EIP, HART & N2 Profile Mappings

F US Clamp-on Communications Protocol Manual
Hardware Installation Manual, 11/2015, A5E34981613-AC
67
Appendix A
A
A.1
Modbus, EIP, HART & N2 Profile Mappings
A.1.1
Introduction
To determine the flowmeter firmware version operating system part number:
1. At the meter, press the <MENU> key.
2. At [Meter Type] press the <Down Arrow> and scroll to [Meter Facilities].
3. Press the Right Arrow>.
4. Press the <Down Arrow and scroll to [System Info].
5. Press the <Right Arrow>.
6. Press the <Down Arrow> and scroll to [Op System P/N] and read your flowmeter Op
System part number.
Profile Definitions
1 = Channel 1
CO = Clamp-On
2 = Channel 2
RF = Reflexor
3 = Channel 3
1+2+3+4 = 4 Channel Sum
4 = Channel 4
1+2 = Channel 1 + Channel 2
DP = Dual Path
1-2 = Channel 1 - Channel 2
QP = Quad Path
①
Flowmeter
④
Clamp-on
②
Dedicated Dual
Channel
⑤
Channel 2 Reflexor
③
Channel 1
Figure A-1 Profile Example