Siemens SITRANS F US - Page 65

WEB Configuration Utility
6.1 WEB Configuration Utility
F US Clamp-on Communications Protocol Manual
Hardware Installation Manual, 11/2015, A5E34981613-AC
63
BACnet Parameters
Figure 6-2 BACnet Parameters
network_nr
This parameter sets the BACnet network number of the Gateway. All BACnet devices that
are created will be on this network. The default is 0 which may be satisfactory for most
simple applications.
site_idx
This is the Site ID of the channel in the meter. For single channel applications it is not
necessary to change this parameter but when the meter has two or more channels it is
necessary for the Site ID to match the name of the meter SITE ID for ALL meter types.
node_offset
This parameter sets the BACnet Device Object address. A Modbus node of 1 will be
(node_offset +1) on BACnet.