Siemens SITRANS FUS080 - History

Introduction
1.2 History
SITRANS FUS080 transmitter
Operating Instructions, 07/2012, A5E03059912-02
9
Application label
The application label is supplied with the device and can be used to show the local
application settings of the transmitter. It is recommended to fill in this label with the
application values and place it on the left side of transmitter.
6LHPHQV$6)ORZ,QWUXPHQWV
0DGHLQ)UDQFH
6,75$16)866212.,77UDFN
6<67(01R0(.$9$=677

$SSOLFDWLRQ9DOXHV
/
'LPHQVLRQ
4PD[
4QRUP
4PLQ
,QVWDOODWLRQGDWH
P

K
P

K
P

K
3XOVH9DOXH
3XOVH:LGWK
&DEOH/HQJWK
&DO)DFWRU
P

SXOVH
P
V
P
1
Figure 1-2 Application label
1.2 History
The contents of these instructions are regularly reviewed and corrections are included in
subsequent editions. We welcome all suggestions for improvement.
The following table shows the most important changes in the documentation compared to
each previous edition.
Edition Remarks FW version EDD version
07/2012 First edition 2.03 01-02-07
The documentation of this edition is applicable for the firmware stated in the table.
Note
A flowmeter system consists of a sensor retrofit kit (SONOKIT) and a transmitter (FUS080).
These Operating Instructions only cover the transmitter part of the system. The sensor part
has a separate manual, which is available on the SITRANS F US literature CD-ROM and on
the flowdocumentation website (http://www.siemens.com/flowdocumentation
)