Siemens SITRANS FUS080 - Connecting; Wiring Power Supply and Output; Wiring the Power Supply

Connecting
5.2 Wiring the power supply and the output
SITRANS FUS080 transmitter
Operating Instructions, 07/2012, A5E03059912-02
25
4. Ground transmitter via grounding terminal (PE) on PCB.
Note
Sensor grounding
To ensure identical potential for sensor and transmitter, a direct grounding of transmitter
and sensor is recommended.
5. Tighten both transducer cable glands.
6. Make sure that transducer cables are not overbent. Minimum cable bend radius is 50
mm.
5.2 Wiring the power supply and the output
The wiring of the power supply and the output is done in three steps:
1. Wiring the power supply
2. Wiring the pulse output (if relevant)
3. Mounting the transmitter
5.2.1 Wiring the power supply
WARNING
Make sure the power supply requirements stated on the nameplates are met!