Troubleshooting/FAQs
9.2 Diagnosing with PDM
SITRANS FUS080 transmitter
Operating Instructions, 07/2012, A5E03059912-02
57
9.2 Diagnosing with PDM
SIMATIC PDM is a suitable tool for diagnosing the device. You can use SIMATIC PDM to
read all parameters available in FUS080 to a table for analyzing offline, view online/actual
process values and online/actual diagnostic information.
Requirements
The following procedure must be completed before diagnosing:
● Connection of Modbus interface via PC and IrDA, see also "Commissioning via PDM
(Page 32)
● Installation of PDM and FUS080 PDM driver, see also "Installing the device driver
(Page 34)
Diagnosing with PDM
Online process values are available under menu "View" → "Display".
The "Measured Track Values" tab shows the gain steps and the flow velocities for path 1 and
path 2. For 1-path applications the values for path 2 (track 2) are "0".
The gain steps depend on the pipe size and the conditions of the measuring media.
The flow velocities depend on the flow in the pipe.
To Next Page
Loading...
