SITRANS FUS080 transmitter
Operating Instructions, 07/2012, A5E03059912-02
69
Parameter lists
A
The following tables show the various parameters available via PDM.
The parameters are accessible at three different levels:
● Read: Maintenance level
● Read/Write (R/W): Specialist level (write access is only permitted after entering the user
password; default password is 1000)
● Hardware locked (HW key): The parameter is only accessible when a HW key is mounted
A.1 Identification
Table A- 1 Identification parameters (FW 2.03 and EDD 1.02.07-01)
Modbus
Address
Parameter Default
value
Value range Access
level
Description
40049 1 Application identifier Identity R/W Customer application identification
information (max 16 characters)
40057 2 Application location Location R/W Customer application location
information (max 16 characters)
Device
40032 5 Sensor size Product
dependent
See
"Dimension
dependent
settings",
SONOKIT 2-
path and
"Dimension
dependent
settings",
SONOKIT 1-
path
R/W Pipe diameter of the sensor. It is only
a text field for measurement system
information. The value has no
influence on the measurement. Please
see inner diameter at pipe date in
parameter 306
40141 8 Totalizer unit m
3
See "unit
conversion
table"
R/W Totalizer unit as text for volume.
Change the unit in parameter table if
the device menu 'Unit guide (offline)'
does not list the wanted unit.
Note: The device display can show
'm3' unit only - other units cannot be
shown on the display, but will be used
and shown online via PDM
To Next Page
Loading...
