Siemens SIWAREX FTA - Calibrating Applications

Calibrating Applications
SIWAREX FTA
12-178
12 Calibrating Applications
12.1 General Note
!
Attention
Calibratable scales may only be certified by a calibration expert or qualified
representative.
Preparations
The following preparations must be made by the scale users before the
actual certification by the calibration expert:
Start SIWAREX FTA
• Adjust the scale according to the device manual
• Check all of the points corresponding with (1), (2), (3) and (4).
(1) = European Regulations ER (90/384/EWG) on non-automatic
weighing instruments
(2) = European Standards EN 45 501 for non-automatic weighing
instruments
(3) = National regulations for automatic weighing instruments
(4) = The corresponding OIML recommendations for automatic weighing
instruments
(5)= Conditions listed in the corresponding certificates.
Calibration sticker
The calibration sticker is found in the calibration set which you can get as an
accessory.
Certifying the
SIWAREX FTA
The certification of the calibrated scale is done by a calibration expert from a
recognised position.
Stamp of approval on
SIWAREX FTA
After activating the write protection (WRP switch on the front), the calibration
expert attaches the certification stamp and the calibration mark.