Sierra Wireless FX30 - Useful AT Commands

Sierra Wireless FX30 User Guide
Rev 4 March 2019 32 41110030
4. Connect to the AT command port. Set the terminal program com port to
match the port number you found for the Sierra Wireless WWAN Modem. You
should now be able to issue AT commands to the modem. If the connection
fails, check the serial port settings.
5. Use the terminal program to SSH to root@192.168.2.2 and establish a
secure shell connection, The first time you connect, you are prompted to
change your Linux root password.
Note: Ensure that you create an effective password that is longer than eight characters,
and uses special characters, numbers, and upper and lower case characters.
Useful AT Commands
The radio module for the FX30 is the Sierra Wireless AirPrime
®
WP8548,
WP7601-1, WP7603-1, WP7607-1, or WP7702. Useful radio module AT
commands include:
• Test AT command interface: AT should answer OK
• Get device information: ATI
• Get SIM status: AT+CPIN?
• Enter SIM PIN code: AT+CPIN=XXXX
• Configure APN: AT+CGDCONT=1,"IP","xxxxxx.xxx"
• Check APN configuration: AT+CGDCONT?
• Check signal quality: AT+CSQ
• Check network registration: AT+CREG?
• Check GPRS network registration: AT+CGREG?
• Check operator selected: AT+COPS?
• Check for PDP context status: AT+CGACT?
• Check for modem status: AT!GSTATUS?
• Open a LWM2M session to connect AirVantage: AT+WDSS=1,1
Warning: Do not use the AT+KSIMSEL command with the FX30. This command has the
capability of asserting GPIO6 when setting the <sim_slot> parameter to 1, causing the
FX30 to malfunction.
Setup for Linux Shell Commands
You can communicate with the FX30 using Legato shell commands. Before
beginning, install a Linux terminal application such as minicom or microcom.
To connect to the USB port on the Linux shell:
1. Connect the USB port on the FX30 to the computer.
In Linux, the AT command port and NMEA port are USB serial devices
located at /dev/ttyUSBx where x is the serial device number in the order it was
connected. X depends on the number of USB serial devices you have con-
nected.
2. Connect an SSH client root@192.168.2.2