Specifications
Rev 4 March 2019 49 41110030
• Airplane mode—The application processor is fully functional and the WWAN
radio is off; the GNSS radio can be turned on/off. By default the GNSS radio
is on.
Depending on the application, you can lower power consumption by disabling the
Ethernet interface and GPS bias using GPIO52 and GPIO55 respectively. (See
Table D-1 on page 74.)
Power Consumption
Table 3-13: Power Consumption — Active Mode FX30 3G (WP8548)
Mode Conditions Voltage Max continuous Burst
V mA mW mA mW
Active Idle
USB and
Ethernet
cables are
plugged in
24 40 960
12 74 888
4.5 180 810 208 936
Active Full
Function
WCDMA
Max Tx power (+23 dBm)
USB 70 Mbps
Ethernet 55 Mbps
24 138 3312 145 3480
12 265 3180 270 3240
5 604 3020 645 3225
Active Full
Function GSM
Max Tx power (+31 dBm)
USB 70 Mbps
Ethernet 55 Mbps
24 110 2640 308 7392
12 212 2544 600 7200
5 550 2750 1670 8350
Table 3-14: Power Consumption — Active Mode FX30 Cat-1 (WP7601-1)
Mode Conditions Voltage Max continuous Burst
V mA mW mA mW
Active Idle
USB and
Ethernet
cables are
plugged in
24 56 1364 236 5672
12 114 1371 532 6382
4.5 254 1141 1339 6027
Active Full
Function LTE
Max Tx power (+33 dBm)
USB 110 Mbps
Ethernet 94 Mbps
24 212 5101 317 7611
12 397 4767 719 8625
4.5 1048 4716 1804 8118
To Next Page
Loading...
