Simplex 4100+ Guide

Page 42 of 60
42 of 60
of 60
of
5 of 1
60
5.1 QE90 Service Isolation Mode – Fault Display
To access the fault memory and communications errors facility of a QE90 panel follow these steps;
1. Put the panel into „Isolate‟ [I.e. move key-switch to Isolate position]
2. Press and hold the BGM/PAGING key for 2 seconds until PROGRAM LED (only) is on.
3. Press BGM/PAGING key successfully until LAMP TEST is flashing
The Fault memory will be displayed
ALERT LEDs will display the binary equivalent of the COMMS ERROR COUNT:
Zone 3 = 1
Zone 4 = 2
Zone 5 = 4 etc
When the LAMP TEST button is flashing refer to the following pages for some descriptions of the faults
indications displayed

Simplex 4100+ Specifications

General

Type	Addressable Fire Alarm Control Panel
SLC Loops	Up to 10
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	10% to 93% non-condensing
Display	LCD
Communication	Ethernet
Power Supply	120/240 VAC, 50/60 Hz
Battery Backup	24 VDC
NAC Outputs	Expandable
Releasing Capability	Yes, with releasing modules
Max Notification Appliance Circuits (NACs)	Varies by modules
Max Releasing Circuits	10
Communication Ports	Ethernet
Max Devices	3, 000