Simplex 4100+ - What to do if a MAPNET II Point Will Not Reset

Page 54 of 60
54 of 60
of 60
of
5 of 1
60
5.8 ECP Failures
5.8.1 MECP and SECP Failure
A MECP failure will be present on any SECP when communications is lost and/or the panel has failed to activate
correctly. In a similar fashion, an SECP failure will be present when communications is lost and/or the panel has
failed to activate correctly.
5.8.2 WIP MECP and SECP Failure
A WIP MECP failure will be present on any SECP when a WIP Line fault or WIPS Module failure is detected on
the MECP. In a similar fashion, any WIP SECP failure will be present on any SECP when a WIP Line fault or
WIPS Module failure is present on the SECP/s.
5.8.3 Paging Console Failure
A paging console failure will be observed when a loss of communication to the Paging console/s is discovered.
5.9 ECM Networked Systems
If you are having issues with an ECM Network and are unable to diagnose a fault/trouble – please contact your
local Simplex® Personnel who will be able to assist.