CP42/50/52 SETUP menus Chapter 9
106
DELETE MEMORY:
1
Delete all WAYPOINTS
2
Delete all ROUTES
3
Delete all LINES
4
Delete all TRACKS
5
Delete all TARGETS
Used memory: 0%
Factory presets:
6
Return to NMEA presets
7
Return to CHART presets
CLR
Return to all factory presets
0
Show test display
MENU
Exit
Attempting to make any type of change from this display will first of
all generate a
WARNING
display that you are about to erase some or all
data/settings.
If you are absolutely sure, press
[ENT]
to complete the job.
If not absolutely sure, then press
[MENU]
to exit the function.
Poweroff-Reset
In case, for some reason, the unit is totally locked i.e. no immediate
response from the keypad, the unit can be reset by disconnecting the
power supply and then started up again.
Master reset (will return all settings to factory presets)
If the Power off - reset does not solve the problem, you may have to
perform a master reset by disconnecting the power supply, and then
while reconnecting the power cable you will have to press the [PWR]
and [CLR] keys at the same time, and hold both keys depressed until a
picture appears on the screen. All user-made data will be erased, and
all settings are returned to factory presets.
To Next Page
Loading...
Need help?
General
