CP42/50/52 Chart menus and INFO windows Chapter 3
29
3.3.8 GOTO function
CHART
GOTO
Shortcut to Chart 1, press again to call up INFO window with available
navigation modes:
Select NAV mode
1
Cursor
2
Waypoint
3
Route
4
Track
5
Anchor guard
MENU
Exit
To select “Cursor” navigation will require
that the cursor is active.
“Waypoint”, “Route” and “Track”
navigation will require there is one stored
in the memory before it can be activated.
The NAV mode can also be activated from
the NAV menu.
For further details on the different NAV modes, refer to chapter 4.
Waypoints and navigation.
Anchor guard – When setting anchor, check/change the preset alarm
distance etc., so you will be warned in case you drift too far from the
anchored position. The alarm distance can be set anywhere from 0.01
to 9.99 nm in Navigation setup display. See also section 6.3 Anchor
guard.
If pressing the
[GOTO]
key while one of the NAV modes is active, this
pop-up window will appear on the screen:
Navigation is ON
1
Advance
2
Restart to approaching point
3
Turn NAV off
MENU
Exit
Press [1] to advance to next waypoint in the route (Route navigation).
Press [2] if you for some reason have drifted off course and wish to
restart navigation from your actual position to the approaching point.
To Next Page
Loading...
Need help?
General
