Simrad CP50 User Manual

CP42/50/52 Waypoint/route menus Chapter 5
54
If the XTE distance is not the same in all legs, the value will be *.*
instead of the 0.10nm. Navigation mode can be either Rhumbline or
Great circle, or … if not set to the same in all legs in a route, the mode
will be:
COMPOSITE.
Direction in route: can be set to either
FORWARD
or
REVERSE
direction.
Show route as:
NAVIGATION for navigational data in the route display
(example on the previous page), or
POINTS
for a list of route points
together with the points’ position in lat/lon and the XTE limit.
Place the cursor on the function you wish to change
0-9
Key in new figures, and…
+/-
toggle between available values
- if no more alterations are required, go to [ENT], or you can insert/re-
move routepoints from the route by entering a new display:
PLOT
Open for the function: Remove/insert routepoints
+/-
Existing routepoints can be removed, by using the +/- keys to highlight
CLR
the routepoint you wish to remove, and press [CLR]
New routepoints can be added to the route by using the cursor to go
up/down in the WP list to select the position you wish to add to the
route, then…
+/-
By means of the +/- keys highlight the routepoint where you wish the
PLOT
new position should be placed in the route, and press [PLOT]
- the last point in the RtePt panel is empty, and as such will allow you
to enter a new final routepoint.
ENT
Confirm modification of route and return to the Edit display
- or abandon modification by pressing [MENU]
ENT
Confirm editing
MENU
Return to route list

Simrad CP50 Specifications

General

Brand	Simrad
Model	CP50
Category	GPS
Language	English