Singer EM9305 - Threading the Upper Thread 2:5

D
C
A
B
E
2:5
Set Up
THREADING THE UPPER THREAD
Makesurethepresserfootisraisedandtheneedleisintheup
position.
1. Place the thread on the spool pin and the spool cap on the
spoolpinasdescribedonpage2:4.
2. Spool pin in horizontal position:
Bringthethreadoverandbehindthepre-tensionthread
guide(A)andunderthethreadguide(B).
Spool pin in vertical position:
Insteadofbringingthethreadintothepre-tensionguide
(A),bringitdirectlyunderthethreadguide(B).
3. Bringthethreaddownbetweenthethread tension discs
(C).
4. Continuethreadinginthedirectionindicatedbythearrows
intheillustrationabove.Bringthethreadfromtheright
into the slot on the take-uplever(D).
5. Takethethreaddownandbehindthelastguidejustabove
theneedle(E).