4:4
A
B
C
D
TO HOOP THE FABRIC
For the best embroidery results, place a layer of stabilizer
beneath the fabric. When hooping stabilizer and fabric make
sure that they are smooth and securely hooped.
1. Open the Quick Release (A) on the outer hoop and loosen
the screw (B). Remove the inner hoop. Place the outer hoop
on a rm at surface with the screw on the lower right.
There is a small arrow in the center of the lower edge of
the hoop which will line up with a small arrow on the inner
hoop.
2. Place the stabilizer and fabric, with the right side facing up,
on top of the outer hoop. Place the inner hoop on top of the
fabric with the small arrow at the bottom edge. If you can
see the hoop size in the lower part of the inner hoop, you
have attached it correctly.
3. Push the inner hoop rmly into the outer hoop.
4. Close the Quick Release (A). Adjust the pressure of the
outer hoop by turning the retaining screw (B). The fabric
should be taut in the hoop for the best results.
Note: When embroidering additional designs on the same
fabric, open the quick release, move the hoop to the new
position on the fabric and close the quick release. When
changing type of fabric, you might need to adjust the pressure
using the retaining screw. Do not force the quick release.
SLIDE ON/OFF THE HOOP
Slide the hoop connector into the hoop attachment (C) from
front to back until it clicks into place.
To remove the hoop from the embroidery arm, press the grey
button (D) on the hoop attachment and slide the hoop towards
you.
To Next Page
Loading...
