Singer EM9305 - Embroidery Settings

3:6
EMBROIDERY SETTINGS
Selective Thread Cutter auto for embroidery
The Selective Thread Cutter auto in the Embroidery Settings is
activated by default. The threads are cut automatically and the
presser foot raises at color changes or when an embroidery is
nished. When deselected, no Selective Thread Cutter auto will
be performed.
Automatic Jump Stitch Trim
This machine features Automatic Jump Stitch Trim. This
function saves you time trimming after the embroidery is
completed. The upper thread will be cut and pulled to the
underside of the fabric when starting to embroider after a color
change, at the rst color block, after stepping stitches and when
the machine continues to embroider after a jump stitch.
Thread cuts will be automatically performed in e.g. the
following situations:
• Upper thread is cut automatically and the presser foot raises
at color changes.
• Bobbin thread and upper thread are cut and the presser foot
raises when an embroidery is nished.
• Upper thread is cut automatically at the start of a jump
stitch.
• Cut commands in designs.
Note: Hold the thread tail when you start embroidering or at a
new color block so that you can easily remove the thread end
when cut.
Note: If the front and back of your embroidery will be visible,
turn off the automatic jump stitch trim and cut the threads
manually.
Note: If your designs are very close together, e.g. lettering or
programmed stitches, turn off the automatic jump stitch trim
and cut the thread manually.
Hoop Selection
Touch the Hoop Selection icon and select the hoops you own.
When you rst load a design, the machine will select the most
suitable hoop among the ones you have entered in the Hoop
Selection.
Note: In the hoop list you will nd that some hoop sizes are
followed by a letter. These are specialty hoops. For example, E
stands for endless hoop and M for metal hoop.
Presser Foot Height
You can adjust the height of the presser foot in Embroidery
Stitch-Out mode when using your SINGER
®
Snap On
Embroidery Foot R.
Some embroideries may build up under the presser foot. If
there is not enough space between the presser foot and the
embroidery, the top thread will form loops on the underside of
the embroidery. Increase the presser foot height in small steps
until the embroidery moves freely under the presser foot.