4:6
6. Clear sufcient space around the machine to accommodate
movement of the embroidery arm and the hoop. Hold the
needle thread and touch the Start/Stop button. The machine
starts embroidering.
Note: This machine features Automatic Jump Stitch Trim. When
activated the machine trims the top jump stitch threads and
pulls the thread ends to the underside of the fabric. The default
setting is on. To turn it off, go to the SET Menu, Embroidery
Settings and deselect Automatic Jump Stitch Trim. Read more
about Automatic Jump Stitch Trim in “Automatic Jump Stitch
Trim” on page 3:6.
If Automatic Jump Stitch Trim is not activated the
machine will stop after stitching a few stitches. A pop-up
message will appear on the screen asking you to cut the
thread end. Cut the thread and press Start/Stop to continue
embroidering.
7. When the rst color is completed, your machine cuts the
top thread and stops. A pop-up message appears asking you
to change thread color. Re-thread with the next color and
continue embroidering by pressing Start/Stop. Hold the
thread end. The machine will trim the top thread end and
you can pull it loose.
At the end of each color block, the thread is tied off and the
needle thread is cut.
8. When the embroidery is completed, your machine cuts the
top thread and bobbin thread and stops. The needle and
presser foot raise automatically for easy removal of the
hoop.
A pop-up message and sound informs you that your
embroidery is nished. Touch OK to keep the design loaded
and stay in Embroidery Stitch-Out Mode.
To Next Page
Loading...
