6:9
Check Needle Thread
The machine stops automatically if the needle thread runs
out or breaks. Re-thread the needle thread, close the pop-up
message, go back a few stitches using the Step Stitch-by-Stitch
control and start embroidering again
Machine needs to rest
If the machine stops and this pop-up appears on the screen,
the machine needs to rest. When the OK icon is enabled you
can resume embroidering. The embroidery results will not be
affected.
Raise needle
If the needle is lowered with the handwheel to check the needle
position on the fabric, a pop-up message is displayed to prevent
damage to the needle and fabric when trying to adjust the hoop
position. Make sure the needle is above the fabric and touch
OK.
To Next Page
Loading...
