© Mar. 2023
10 AB16EJ Plus Maintenance Manual
MAINTENANCE SAFETY PRECAUTIONS
NOTICE
• It is forbidden to place other ob-
jects and tools on the battery to
prevent short circuit in the
battery.
• It is forbidden to tap, throw or
step on the battery, or hit it with
sharp parts.
• Do not immerse the battery in
water, acidic, alkaline or salty sol-
utions, and protect the battery
from rain.
• The battery should be fully
charged immediately after each
use of the machine, and then the
machine power switch should be
turned off.
NOTICE
Battery over-discharge (continued use of battery with
level of less than 10%) or battery under-voltage
caused by long-term non-charging (battery with level
of less than 10% not charged for more than three
days), resulting in battery capacity attenuation and
failure, shall not be covered by the warranty.
2.4 CONSIDERATIONS AFTER
MAINTENANCE
1. Check the machine functions so that faults such as
oil leakage or poor operation can be detected as
early as possible.
2. After maintenance, all maintained parts must be
checked for abnormal operation, oil leakage, loose
bolts and other problems.
3. The safety protective device needs to be restored or
reinstalled, and if necessary, be recalibrated.
4. After maintenance, clear up the tools and equip-
ment for maintenance, remove the replaced parts
and loose objects, and clean up the site.
5. Record inspections and maintenance as required.
NOTICE
All maintenance work should include mandatory
confirmation that the machine is operating properly.
• It is forbidden to dump waste liquids at will.
Waste liquids should be discharged into ap-
propriate containers.
• Waste hydraulic fluids, fuels, coolants and re-
frigerants should be recycled or disposed as
per local regulations.
To Next Page
Loading...
