AB16EJ Plus Operation Manual
47
© March 2023
8 EMERGENCY PROCEDURES
This chapter describes the steps to follow in the event of
unexpected situations during operation.
8.1 REPORTING ACCIDENTS
In case of any accident involving Hunan Sinoboom Intel-
ligent Equipment Co., Ltd. products, Hunan Sinoboom
Intelligent Equipment Co., Ltd. must be notified immedi-
ately. In case of any accident involving the machinery of
Hunan Sinoboom Intelligent Equipment Co., Ltd., notify
Hunan Sinoboom Intelligent Equipment Co., Ltd. by tele-
phone immediately and provide all necessary details,
even if the accident did not cause personal injury or
property damage.
Failure to notify the manufacturer within 48 hours of the
incident involving the machinery of Hunan Sinoboom In-
telligent Equipment Co., Ltd. may void the product
warranty.
NOTICE
Thoroughly inspect the machine and all its functions
after any accident. First, test all functions from the
ground controller, then from the platform controller.
Ensure the machine's lifting height does not exceed
3 m (10 ft) until all damage has been repaired and all
controllers operate properly.
8.2 EMERGENCY OPERATION
When the operator is unable to control the ma-
chine (squeezed or trapped on the platform):
1. Other personnel can only operate the machine from
the ground controls according to the operation
requirements.
2. Other qualified personnel on the platform can oper-
ate the platform controller. If the controller is not
working properly, do not continue to operate.
3. A crane, forklift, or other equipment that meets us-
age condition requirements can be used to transport
personnel on the platform and stabilize the move-
ment of the machine.
When the platform or boom is stuck at height:
If the platform or boom is stuck or blocked by a high
building or aerial equipment, rescue the operator on the
platform first before attempting to free the machine.
If any switch is reset but the movement does
not stop:
If any switch/handle returns to neutral position and the
corresponding movement does not stop, remove the
foot from the foot switch or push in the emergency stop
button to stop the machine.
8.3 EMERGENCY LOWERING
When the main power source fails, the auxiliary power
on the ground or platform controls can be used accord-
ing to the actual condition to lower the platform into
place. Refer to section Page 44, 7.10 Auxiliary Power
for detailed procedures.
8.4 EMERGENCY TOWING
• Except in case of emergency situations, ma-
chine malfunction, power loss or loading/un-
loading, it is strictly prohibited to tow or drag
the machine.
• When towing or dragging the machine, com-
ply with local policies and road traffic
regulations.
• Towing the machine on public highways is
prohibited.
• The machine is not equipped with a brake for
towing control, so the towing vehicle must be
able to control the machine at all times, other-
wise the machine may lose control, resulting
in serious injury or death.
• The maximum permissible towing speed is 3
km/h (1.9 mph).
• The maximum permissible towing gradient is
25%.
• The machine must not be towed/dragged with
the engine running or the drive hub engaged.
• Before the brake is released, the machine
must be parked on a horizontal surface or
secured.
To Next Page
Loading...
