Sinoboom TB20J Plus - Test-Run Information; Sensor Calibration

To Next Page

To Previous Page

CONTROL SYSTEM

TB20J Plus Maintenance Manual 143

Fig 4 LANGUAGE Interface

3. Select 中文 or English through

and , and press

and hold

for 3s to complete language setting.

4. Press

successively to return to the main inter-

face, and power off the machine as required.

11.5 TEST-RUN INFORMATION

1. Press on the main interface to enter CONFIGU-

RATION interface.

2. According to the navigation diagram of display inter-

face, enter TEST-RUN INFO interface by pressing

, and .

Fig 5 TEST-RUN INFO Interface

Sensor Calibration

• This operation is to calibrate sensors other than the

weighing sensor (its calibration method will be de-

scribed in detail in the subsequent weight calibra-

tion ).

• If the machine is equipped with a dual-channel sen-

sor, only 1 channel is needed to be selected for max-

imum value and minimum value calibration.

1. On the TEST-RUN INFO interface, select Sensor

Calibration through

and and enter SENSOR

CALIBRATION interface by pressing

Fig 6 SENSOR CALIBRATION 1 interface

Fig 7 SENSOR CALIBRATION 2 interface

Fig 8 SENSOR CALIBRATION 3 interface

2. On the SENSOR CALIBRATION interface, select

the position to be calibrated through

and

(there will be the flashing before the selected op-

tion), press and hold

for 3s to complete the cali-

bration (the icon before the selected option is

Other manuals for Sinoboom TB20J Plus