Escape holes
Sometimes you have to increase your clearance or create extra
escape holes for the powder to get out f.ex when you have moving
parts like hinges over a long distance. We recommend making in
the model at least 4 [mm] diameter for one escape hole, 2 [mm] for
two or more.
4. Installation of the printer
To ensure safe use of the Sinterit Lisa Printer, please read and follow the instructions below.
Keep this manual for future use. Also, be sure to follow all warnings and instructions marked
on the product.
WARNING!
Only trained and qualified personnel should install, replace or service the
equipment.
The device should be installed in accordance with these instructions and by
trained personnel.
A. Environment and place of installation
● The Sinterit Lisa Printer should be placed at room temperature.
● The room must be well ventilated, adequately to its size.
● The product should be placed on a flat, stable surface that extends beyond all edges
of the product. If you place the product by the wall, the distance between the product
and the wall should be greater than 500 [mm] (20 [in]).
● The product will not work properly if it is set at an angle.
ATTENTION! Do not place or store the product:
● outdoors;
● in areas with large amounts of dust;
● in places subject to shocks, vibrations, high temperature and/or
humidity, and extreme changes in temperature and humidity;
● near water, or heat sources;
● near inflammable and volatile substances, concentrated acids or
corrosive vapours;
● in places easily accessible to children and animals.
15 Sinterit Lisa USER MANUAL
To Next Page
Loading...
