6. After cleaning, the product possesses its full durability and is ready to be used.
* A Sandblaster and Powder Sieve may be optionally included in the set. Contact
Sinterit or a Sandblaster seller in order to select an abrasive which may be used to
clean PA12 Smooth.
A. Painting and lacquering
SLS parts are able to be spray painted and/or coated with a lacquer (varnish or clear coat).
Via lacquering it is possible to obtain various finishes, such as high gloss or metallic sheen.
Lacquer coatings can also improve wear resistance, surface hardness, water-tightness and
limit marks and smudges on the surface of the part. Due to the porous nature of SLS it is
recommended that 4- 5 very thin coats are applied to achieve a final finish rather than one
thick coat. This results in faster drying time and reduces the likelihood of the point or lacquer
running.
12. Maintenance and service of the Sinterit Lisa
Printer
To maintain the most efficient and long-lasting Printer, ensure regular conservation. The
basic maintenance contains:
● cleaning the pyrometers and the camera protective glasses before and after each
print,
60 Sinterit Lisa USER MANUAL
To Next Page
Loading...
