WARNING!
During printing, if smoke, irritating smell or other alarming circumstances take
place, press the safety button. It will immediately cut off the power from the
printer. However, remember that it is impossible to open the printer (f. ex..: by
lifting the lid), until the temperature inside will not drop below 49 [
o
C].
D. Finishing the print in ADVANCED MODE
1. Put on the safety clothing included in the set (mask, glasses, gloves).
2. When the printing is complete and the print cooled down the PRINT FINISHED
command will appear on the main screen. Click it to complete the printing process
and open the printer.
IMPORTANT!
The blockade of the device is engaged until the internal temperature drops
below 49 [⁰C].
There is no possibility to open the lid before the temperature drops.
Remember that the print inside the printer may still be hot, despite the fact
that the printer has cooled down!
3. In order to open the printer, unlock the magnetic lock on the lid (PRINT//UNLOCK
LID). The lock releases the blockade for 10 seconds. After 10 seconds the lock will
become active again.
4. Softly press the lid and then lift it by pulling up.
WARNING!
Do not move the Recoater manually. It is allowed only using commands on
the screen.
53 Sinterit Lisa USER MANUAL
To Next Page
Loading...
