Transfer it to the container in which you will mix the powder from the printer with the Fresh
Powder later (to refresh the used powder and prepare it for the next print).
9. Place the Overflow Bin back in its place.
10. Confirm operation by clicking “DONE” and close the lid.
CAUTION!
Beware of sharp edges.
10. Printing - ADVANCED MODE
1. Switch the power button (from “0” to “1”) located on the back. Place the key in the
ignition and turn it right, clockwise, at a quarter of a turn.
Image. Off/On key position.
WARNING!
Check whether the safety button is out. If not, release it by turning it
clockwise at a quarter of a turn.
After switching on the Sinterit Lisa, the startup screen will be displayed. Choose the
“ADVANCED MODE” option.
46 Sinterit Lisa USER MANUAL
To Next Page
Loading...
