6. Initial startup of the device after delivery
1. Take the printer out of the package. Carefully discard protective foil and paper.
2. Place it on a stable and hard surface (ideally the target location of the printer).
3. Connect the power cord.
4. Switch the power button (from “0” to “1”) located on the back.
5. Check whether the red safety button is out. If not, rotate it clockwise at a quarter of a
turn (the black flange of the button).
6. Place the key in the ignition and turn clockwise at a quarter of a turn. After a moment,
the device will start.
Image. Off/On key positions.
19 Sinterit Lisa USER MANUAL
To Next Page
Loading...
