● Pay special attention to the fact that the power cables are not bent at
the points of connection of the printer.
● Disconnect the plug whenever it is planned to shift/transfer the device.
In the following situations, unplug the product from the power supply and contact a qualified
service personnel:
1. the power cord or plug is damaged,
2. some liquid got into the product,
3. the product has been dropped or the case has been damaged;
4. the product does not operate properly or clear changes in efficiency have been
observed.
Do not adjust controls that are not described in the manual.
ATTENTION! Do not:
● spill liquid on the product;
● put any containers on the equipment, in particular containing water;
● handle it with wet hands;
● block or cover the vents and openings in the product;
● touch movable parts.
ATTENTION! If the device is not used for a long time (e.g. vacation), unplug
the power cord from the socket.
5. Sinterit Studio software - installation
Technical requirements to install Software:
● Windows 7 or higher,
● Minimum 500 MB of disk space,
● Minimum 2 GB of RAM,
● Graphics adapter compatible with OpenGL 3.0 or higher.
1. Connect the USB flash drive included in the set to the computer USB port.
2. Locate the Sinterit Studio folder.
3. Open SinteritStudioSetup.exe.
17 Sinterit Lisa USER MANUAL
To Next Page
Loading...
