ATTENTION!
● Never use wood, equipment with wooden elements and flammable
substances while working with the printer.
● The minimum distance between the printer and wooden parts is 200
[mm].
● The printer emits large amounts of heat (60
o
C), and therefore it is
prohibited to place it on wood or wooden furniture.
B. Power supply:
● Use only the power cord supplied with the product.
● The printer must be connected to a grounded outlet to prevent electric shock in the
event of a fault.
● When connecting/disconnecting the plug to/from the power source always hold the
cover, not the cord.
WARNING!
Do not use cables from other devices. Using the power cables from other
devices or connecting the power cord supplied with the product to other
devices may cause fire or electric shock.
ATTENTION!
Never disassemble, modify or repair the power cord, plug, devices inside the
printer, except as described in the product manual.
● The product should be placed near a wall outlet, which can be easily unplugged.
● It is recommended to use UPS units that, in the case of a momentary power failure,
will allow the printing process to finalise.
● When an extension cord is used for the power supply of the product, make sure that
the total power consumption of all devices connected to it does not exceed the
extension cord's limit. Also make sure that the total current drawn by connected
equipment does not exceed the ampere rating for AC wall outlet.
● Power cables should be placed in such a place that they are not rubbed, cut, pulled or
twisted.
ATTENTION!
● Do not place objects on the power wires.
● Do not place power cords in path where people will have to walk
or run.
16 Sinterit Lisa USER MANUAL
To Next Page
Loading...
