Image. Cleaning the laser protection glass
d. After the cleaning, put the glass back into the metal frame. To assemble the laser
glass protective socket, slide the tabs into the holes on the left side of the heating
module. Press the module gently to the lid and then screw the wings on the right side.
STOP!
● Watch out for the elements of the heating system of the machine.
● Do not clean the glass under running water.
● The cleaning process should be carried out outside of the device.
C. Cleaning the surface under the Beds
ATTENTION!
Before cleaning, turn the printer off.
CAUTION!
Beware of moving parts which can crush hands.
Pay attention to the indications inside!
To facilitate cleaning of the space under the Beds Sinterit reinvented the front panel
assembly. Now under the panel, you will find plastic hooks which allow you to remove it fast
and simple.
64 Sinterit Lisa USER MANUAL
To Next Page
Loading...
