A. Preparing the device:
1. Remove the key and press the safety button. Remove the power cord.
2. Remove the laser protection glass and wrap it in a bubble wrap. Put the glass in a
box outside the device.
3. Place the bubble wrap in the upper flap to secure the laser module and close the
printer’s lid.
4. Manually move the Recoater to the center of the print chamber and secure it with a
bubble wrap (the foil should be on the Print Bed and Source Bed).
5. Be careful not to apply too much foil, and not to damage the infrared heaters in the
flap when closing.
6. Close the device.
Attention!
Repack the product in the original manufacturer's packaging, complete with
the inner cushioning material.
B. Packaging:
1. Place 6[cm] of filler material (wrinkled wrapping paper) at the base of the outer box or
flight case before placing the Lisa Printer.
2. Place the printer in its original packaging - centered - then fill in the remaining space
with the original filling - wrinkled wrapping paper.
3. Make sure the printer sits straight and the flap is facing up!
4. Close and seal the box.
5. Secure the package with straps so that it does not move on the pallet,
6. Seal the whole package by stretch.
7. Mark where the top of the device is located.
8. Mark the package as “fragile”.
Attention!
If the product has been shipped on a pallet or in a flight case package, it
should be returned in the same way.
77 Sinterit Lisa USER MANUAL
To Next Page
Loading...
