SINTERIT LISA - Cleaning Laser Protective Glass

CAUTION!
Beware of sharp edges. Put on the safety gloves to protect yourself from
injuring the hand against the side of the heating module.
To open the laser protective glass socket, you need to unscrew the wings on the right side of
it. While doing so, remember to hold the metal frame and then gently draw out the socket.
Now you can take the glass out of the frame and replace it with the new one.
To assemble the laser glass protective socket, slide the tabs into the holes on the left side of
the heating module. Press the module gently to the lid and then screw the wings on the right
side.
Image. Correct placement of the laser protection glass on the heater module.
62  Sinterit Lisa USER MANUAL