Y070.020/GB Page 3
Operation instructions
SIPOS 5 PROFITRON, HiMod
1
General information
1 General information
1 General information
1.1 Safety information
General
The devices referred to in this document applies are components of installations conceived for
industrial applications. They are designed in accordance with the recognized engineering rules.
All work involved in transport, assembly, installation, commissioning, maintenance and repair has to
be performed by qualifi ed personnel.
Qualifi ed personnel within the meaning of the safety instructions of this documentation are all
persons authorized to perform the required tasks according to the standards of safety technology
and which may recognize and avoid potential hazards. They must be thoroughly familiar with the
warnings at the device and the safety instructions of these operation instructions.
For work on power installations, the prohibition of the use of non-qualifi ed persons or similar is
stipulated in EN 50110-1 (formerly DIN VDE 0105) or IEC 60364-4-47 (VDE 0100 part 470).
Correct transport, proper storage, mounting and installation, as well as careful commissioning are
essential to ensure a trouble-free and safe operation.
The availability of this product is restricted according to IEC 61800-3 and may cause radio interfe-
rences in domestic environments. In this case it may be necessary to take additional measures.
■
Leakage
The leakage current of the actuators is typically greater than 3.5 mA. Therefore a fi xed installati-
on according to IEC 61800-5-1 is required.
■
Residual current circuit breakers or monitoring devices
Due to the integrated frequency inverter, a direct current can be induced in the protective
earthing conductor. If the network an upstream residual current device (RCD) or residual current
monitor (RCM) is used, then it must be of type B.
The following is of particular importance:
■
the technical data and information concerning the proper use (installation, connection, ambient
and operating conditions) provided in the catalog, order documents, operation instructions, rating
plate data and in the other product documentation;
■
the general installation and safety guidelines;
■
the local plant-specifi c regulations and requirements;
■
the local environmental conditions, in particular the repeated load which might result when moun-
ting the actuator to a vibrating valve.
■
the proper use of tools, lifting and transport equipment;
■
the use of personal protective equipment, especially in high ambient temperatures and with high
actuator surface temperatures (caused by frequent and long activation times).
Warnings on the device
Danger of crushing. When pressing in the crank hand-
le or the handwheel ensure that neither the hand nor
the fi ngers are crushed, refer to fi gure.
Applicable for devices of the 2SA5.5/6/7/8 and
2SB555/6 series. Indicates the lubricant used. Refer
also to chapter 8.2 “Lubrication intervals and lubri-
cants“.
Fig.: Danger of crushing
To Next Page
Loading...
Need help?
General
