Operation instructions
SIPOS 5 PROFITRON, HiMod
Page 66 Y070.020/GB
9 Spare parts
9
Spare parts
9 Spare parts
9.1 General
With the exception of standardized, generally available components, only original spare parts may
be used. Spare parts are usually supplied as complete subassemblies (see the list below). In the
following representation drawings, designations with 3 digits are listed. These numbers are prefi xed
with „2SY5“ to give the full spare parts designation.
When ordering spare parts, always provide the following information:
1. Order number and works number of the actuator (refer to rating plate),
2. Spare parts designation 2SY5 . . . (see following list),
3. Quantity required.
■
All external metallic housing parts are made of a corrosion resistant aluminum alloy, painted
with color similar to RAL 7037 (silver-gray) as standard and meet the requirements up to corro-
sivity category C5.
■
Other fi nish paint color ► add. version Y35
■
Very high corrosion protection
corrosivity category C5 with long protection time ► add. version L38
9.2 Spare parts list
Our actuators are designed for fault-free operation within the maintenance intervals. As we know
from experience, external causes, may damage the actuator already during the commissioning
stage. For such events, the recommended spare parts are listed in the following table. If you require
other parts, please contact our service.
No. Description
2SY5001 Electronics unit (012 – 042)
2SY5041 Cover for electronic housing
2SY5055 Terminal plugs (X1, X2.1, X2.2, X3.1, X3.2)
2SY5216 Output shaft insert, output shaft form "A":
2SY5218 Set of seals (without illustration)
2SY5220 Signaling gear complete (221,222)
2SY5225 Signaling gear cover
2SY5250 Manual drive
2SY5252 Handle/crank handle with handle
= The last three digits indicate the part numbers in the exploded views.
To Next Page
Loading...