Sirona teneo - Setting the Apexlocator; Switch Instrument Light On;Off; Switching the Preselected Coolant On;Off

65 48 510 D3509
D3509.201.03.03.23 10.2016
89
Sirona Dental Systems GmbH 4Operation
Operating Instructions (USA) TENEO 4.5Dentist element
4.5.8.3
Switching the preselected coolant on/off
Cooling of treatment areas
Via touchscreen
The preselected coolant in the EasyMode Start program operating mode
can only be turned on/off with the foot control buttons, see below.
✔ An instrument is taken from the holder and the Instrument program is
displayed on the touchscreen.
➢ Touch the key of the preselected coolant (
Spray , Air or NaCl ).
 If the key of the preselected coolant is highlighted orange, it will
be switched on together with the instrument when the foot pedal
is activated. If the key is highlighted gray, the coolant is switched
off.
Via foot control
✔ An instrument is removed from its holder.
➢ Press the left button of the foot control.
 If the key of the preselected coolant (
Spray , Air or NaCl ) is
highlighted orange on the touchscreen, it will be switched on
together with the instrument when the foot pedal is activated.
4.5.8.4
Setting the ApexLocator
If your dental treatment unit is equipped with the ApexLocator option, you
can adjust this in the
Motor sub-screen.For more information, refer to the
chapter "ApexLocator" [ → 94], section “Endodontic treatments with
motor". For more information, refer to the chapter "ApexLocator" [ → 94],
section “Implantology/endodontic treatments with motor" [ → 109].
The ApexLocator cannot be used in the
EasyMode Start program
operating mode.
4.5.8.5
Switch instrument light on/off
✔ The sub-screen of the removed instrument is displayed on the
touchscreen.
➢ Switch the instrument light on or off with the
Instrument light key.
 If the key is highlighted orange, the instrument light can be
activated using the foot control.
For the SPRAYVIT M multifunctional syringe, the brightness and
operating voltage of the instrument light can be set, see "Instrument light
on/off and water temperature adjustment".
CAUTION
Instrument can be operated without coolant.
Tooth substance can be damaged by frictional heat.
➢ Always make sure that the treatment area does not overheat
whenever you switch the coolant off.
S
0
S