RF communications equipment
Technical description
Requirements applicable to all ME equipment and ME Systems
a) Compliance for each Emissions and Immunity standards
Emission guidance
The Linear actuator MAX1, MAX3 and MAX64 is intended for use
in the electromagnetic environment specified below.
The customer or user of the actuator should ensure that they
are used in such an environment.
Table 3
Emission tests Compliance Electromagnetic environment- guidance
Radiated electromagnetic field
emissions CISPR 14 (EN 55014)
Group 1
Radiated electromagnetic field
emissions CISPR 14 (EN 55014)
Class B ME equipment class B
b) Deviations from Standards and allowances used (MAX1 and
MAX3 only) see table 4, page 19.
c) Instruction for maintaining BASIC Safety and Essential perfor-
mance for the expected Service life
One time approved in the final application not change is allowed
due to the EMC influence.
Portable RF communications equipment (including peripherals
such as antenna cables and external antennas) should be used
no closer than 30cm to any part of the ME equipment. Other-
wise, degradation of the performance of this equipment could
result
WARNING
!
Note!
Do not change the once installed final application due to
EMC view
This product was tested against actual conditions of frequency
wireless environment present in Europe
WARNING
18
To Next Page
Loading...
Need help?
General
