Section 07 REAR SUSPENSION
Subsection 03 (FORMULA Z 670 SUSPENSION)
07-03-3
1. Remove nut
2. Note plastic washers location
Remove outer sleeve, circlip, top idler wheel
sleeve, spring and thrust washer from top idler
wheel axle.
When reinstalling, push circlip into its groove.
1. Push circlip into its groove
2. THIS SIDE OUT mention
Unbolt bottom end of shock.
SHOCK READY TO BE REMOVED
When reassembling, tighten long torque rod nut
to bottom.
Install shock spring remover (P/N 529 0335 04) in
a vise. Mount shock in it and turn shock so that
spring coils matched spring compressor.
Close and lock bar. Adjust handle horizontal by
changing position of clevis pin.
Push down on handle until it locks. Remove
spring stopper and cap then release handle.
1
A03F2ZA
2
A03F30A
-
CAUTION
Outer top idler wheels
no. 4
must be mount-
ed on their shaft with the mention THIS SIDE
OUT facing outside. Center wheel circlip
must face left side.
A03F31A
1
2
A03F32A
To Next Page
Loading...
