Skyjack SJ20 Service Manual

100
SJ20238886ABA
Section 5 – Procedures Wear Pad Replacement
6. Pull the mast cable out of mast 1 and start to
lower it between mast 1 and mast 2 until the next
tape marker is at the top of the cable carrier.
7. Use the three cable clamps removed earlier to
secure the cable to the mast 2 cable carrier.
8. Raise mast 2 so that the cable loop is visible from
the bottom of the mast.
9. Put a weighted roller into the cable loop.

Skyjack SJ20 Specifications

General

Brand	Skyjack
Model	SJ20
Category	Lifting Systems
Language	English