92
Section 5 – Procedures Wear Pad Replacement
5.13 Wear Pad Replacement
1. Remove and set aside the platform. Refer to
section 5.7 Platform Removal.
2. Remove and set aside the lift cylinder. Refer to
section 5.9 Lift Cylinder Removal.
5.13-1 Mast identification
The masts will need to be removed one section
at a time. Refer to the image below for the mast
identification number when following this procedure..
Mast 5
Mast 4
Mast 3
Mast 2
Mast 1
5.13-2 Remove mast 5 and wear pads
1. Open the service compartment cover.
2. Disconnect the mast connector from the main
harness.
3. Cut zip ties along the cable bundles to free the
mast cable.
4. At the rear of the machine, drill out the rivets that
secure the AC inlet to the chassis.
5. Pull out the AC inlet.
6. Disconnect the wires from the back of the AC
inlet.
To Next Page
Loading...
Need help?
General
