61
Section 5 – Procedures
5.1 General
The following information is provided to assist you in
the use and application of servicing and maintenance
procedures contained in this chapter.
5.1-1 Safety and Workmanship
Your safety, and that of others, is the first
consideration when engaging in the maintenance of
equipment. Always be conscious of weight. Never
attempt to move heavy parts without the aid of a
mechanical device. Do not allow heavy objects to rest
in an unstable position. When raising a portion of the
equipment, ensure that adequate support is provided.
Unless specifically noted otherwise, before beginning
any procedure:
1. Park the mobile elevating work platform (MEWP)
on a firm, level surface.
2. Fully lower the machine.
3. Push in the “ ” emergency stop buttons
on the platform control console and the base
control console.
4. Turn the off/platform/base key switch to the
“ ” off position. Remove the key.
5. Turn the main power disconnect switch to the
“ ” off position.
After completing any procedure which involves
modifying, adjusting, or replacing any hydraulic or
electrical components, perform all of the function tests
given in your unit’s operation Manual.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP to enter or exit
the platform. If you do not obey, there is a risk of
death or serious injury.
WARNING
DO NOT operate any control on the platform
control console without proper fall protection
secured to the designated location in the platform.
Failure to avoid this hazard could result in death or
serious injury!
WARNING
Make sure there are no people or obstructions in
the test area, and there is sufficient space for the
scissor and drive functions required for the given
procedures.
To Next Page
Loading...
Need help?
General
