Skyjack SJ20 Service Manual

16
SJ20238886ABA
Section 1 – Scheduled Maintenance Visual and daily maintenance inspections
1.7-5 Base
Do the inspection that follows:
1
Base weldment, B
▪
There are no cracks in the welds or structure.
▪
There are no signs of deformation
2
Display Panel, B
▪
Make sure the panel is correctly attached, and
there is no damage.
3
Steer cylinder assembly, B
▪
The steer cylinder assembly is correctly
installed.
▪
There are no loose or missing fasteners.
▪
There is no visible damage.
4
Battery charger, B
▪
Make sure that the battery charger is correctly
installed, and in good condition.
▪
Make sure there is no visible damage.
5
Pothole protection, B
▪
Make sure there are no visible cracks or signs
of damage or deformation.
1.7-6 Wheel/tire assembly
A small amount of wear is permitted. But if any of the
wear or damage meets the criteria mentioned below,
the tire should be replaced.
WARNING
Do not use tires other than the tires that Skyjack
specifies for this MEWP. Do not mix different types
of tires or use tires that are not in good condition.
Only replace the tires with the same types that are
approved by Skyjack. The use of other tires can
make the MEWP less stable. If you do not obey,
there is a risk of death or serious injury.
6
8
1
3
5
4
79
2

Skyjack SJ20 Specifications

General

Brand	Skyjack
Model	SJ20
Category	Lifting Systems
Language	English