Skyjack SJ30ARJE User Manual

188
SJ30AJE, SJ30ARJE196274AF
Section 5 – Procedures Grease Points
5.7 Grease Points
5.7-1 Lubrication
Maintaining proper lubrication is essential for the good performance and service life of the mobile elevating work
platform. If the bearing and gear of the MEWP are improperly greased, it could result in component damage.
Grease the Swing Drive
1. Pump grease into each of the three grease nipples located on the front of the swing drive housing.
Grease the Turret Rotation Ring Gear
1. Open the control side cowling.
2. Locate the grease line attached to the lower left side of the base control box.
3. Pump grease into the line until new grease appears around the ring gear.
4. Rotate the turret in increments of 10 to 13 cm (4 to 5 inches) at a time, and repeat step 3 until the entire
bearing has been greased.
Grease the Steer Cylinder Bearing
1. Remove the front base cover to access the steer cylinder.
2. Pump grease into the steer cylinder bearing grease nipple until new grease appears all around the bearing
lip.
Recommended Grease
Swing Drive
Mobilgrease XHP 462 MolyRing Gear
Steer Cylinder
Swing Drive
(3 places)
Steer Cylinder
Bearing
Grease Line
to Ring Gear

Skyjack SJ30ARJE Specifications

General

Brand	Skyjack
Model	SJ30ARJE
Category	Boom Lifts
Language	English