SMA sunny home manager - Setting the Netid on the Sunny Home Manager; Setting the Netid on the SMA Radio-Controlled Socket

Procedure:
1. If another PV system with BLUETOOTH is located within 500m of your system, determine a
free NetID at the planned mounting location of every BLUETOOTH device and make a note of
this (see SunnyExplorer documentation).
2. For all devices that are to communicate with the SunnyHomeManager via BLUETOOTH, set
the previously noted free NetID and commission the devices (see BLUETOOTH device- or
BLUETOOTHPiggy-Back documentation).
3. Note the serial numbers of the SunnyHomeManager and all other SMA devices. For each
SMAradio-controlled socket, also note the load to be assigned to the particular socket.
4. Read off the following data from the SMA devices:
• SunnyHomeManager: serial number and registration ID (see type label on the back of
the SunnyHomeManager).
• All SMAradio-controlled sockets: serial number and connected load
• All other SMA devices: serial number
5. With the exception of the SunnyHomeManager and the SMAradio-controlled socket,
commission all BLUETOOTH devices of the PV system (see BLUETOOTH device
documentation).
5.2.2 Setting the NetID on the SunnyHomeManager
Requirement:
☐ The BLUETOOTH PV system must be commissioned (see Section5.2.1, page34).
Procedure:
• Use a screwdriver to turn the arrow of the rotary switch NetID to the desired NetID (blade
width of the screwdriver: 2.5mm).
5.2.3 Setting the NetID on the SMARadio-Controlled Socket
Setting the NetID for the First Time
1. Insert the SMAradio-controlled socket into an outlet.
☑ The upper horizontal LED glows red for approximately ten seconds, then the vertical
LEDs glow green for approximately four seconds.
2. As soon as the LED display shows 0, keep tapping the touch key until the LED display shows
the desired NetID.
3. To adopt the NetID, wait fiveseconds. During this time, do not tap the touch key.
Changing the NetID
Requirements:
☐ The SMAradio-controlled socket must be inserted in an outlet.
☐ The upper horizontal LED must be glowing orange or green.
5 Mounting and Commissioning Preparations
SMA Solar Technology AG
Installation Manual 35HoMan-IA-en-20