SMA sunny home manager - User Account Management

9.2 Retrofitting Plugwise Radio-Controlled Sockets
This section describes how to retrofit Plugwise radio-controlled sockets for your
SunnyHomeManager system if there is already at least one Plugwise radio-controlled socket
registered in the SunnyHomeManager. When retrofitting devices, observe the maximum number
of devices that can be managed by the SunnyHomeManager (see Section2.3, page12).
Requirement:
☐ The Plugwise Stretch must be available and commissioned.
☐ At least one Plugwise radio-controlled socket must already be registered in the
SunnyHomeManager.
Procedure:
1. Commission the Plugwise radio-controlled socket (see manufacturer's documentation).
☑ The Plugwise radio-controlled socket is displayed in the Plugwise app.
✖ The Plugwise radio-controlled socket is not displayed in the Plugwise app?
It may be that the Plugwise radio-controlled socket is beyond the range of the Plugwise
Stretch.
• Resolve this problem (see manufacturer's documentation).
2. Call up the SunnyHomeManager system in Sunny Portal.
☑ The Plugwise radio-controlled socket will be displayed as a new device in the
SunnyHomeManager system in SunnyPortal.
3. Add the Plugwise radio-controlled socket to the SunnyHomeManager system in Sunny Portal
and configure it (see the user manual "SunnyHomeManager in SunnyPortal"). Configuring
the Plugwise radio-controlled sockets is no different to configuring the SMA radio-controlled
sockets.
9 Retrofitting Devices
SMA Solar Technology AG
Installation Manual 61HoMan-IA-en-20