SMA sunny home manager - 6 Mounting; Requirements for Mounting the Sunny Home Manager

6 Mounting
6.1 Requirements for Mounting the SunnyHomeManager
Requirements for the mounting location:
☐ The mounting location must be indoors.
☐ The mounting location must be protected against dust, moisture and corrosive substances.
☐ The cable route from the mounting location to the router must not exceed a maximum length
of 100m.
☐ The cable route from the mounting location of the SunnyHomeManager to the energy
meters with D0interface must not exceed a maximum length of 15m.
☐ The cable route from the mounting location of the SunnyHomeManager to the energy
meters with S0interface must not exceed a maximum length of 30m.
☐ A minimum distance of 1m must be maintained from devices using the 2.4GHz radio
spectrum (e.g. WLAN devices, microwave ovens). This will prevent reduced connection
quality and data transmission speed.
☐ The SunnyHomeManager must not have radio shielding (e.g. in a metal cabinet).
☐ The ambient conditions at the mounting location must be suitable for the operation of the
SunnyHomeManager (see Section12, page81).
☐ The BLUETOOTH connection between the SMA devices must be possible (see Section6.3
"Checking the BLUETOOTH Connection at the Designated Mounting Location", page39).
Minimum clearances:
☐ The minimum clearances must be maintained to ensure adequate heat dissipation.
SUNNY HOME MANAGER
70 mm70 mm
150 mm
50 mm
50 mm
Figure 13: Minimum clearances
6 Mounting
SMA Solar Technology AG
Installation ManualHoMan-IA-en-2038