Additionally required material (not included in the scope of delivery):
☐ 1 network cable (see Section4.1.4 "System Requirements", page27)
Procedure:
1. Connect the network cable to the device (see device documentation).
2. Connect the other end of the network cable to the router or network switch.
☑ The device is automatically recognized by the SunnyHomeManager. Once you have added
the controllable device to the SunnyHomeManager system via the configuration wizard in
SunnyPortal, the SunnyHomeManager will control the device automatically via the defined
data exchange protocol.
7.6 Supplying the SunnyHomeManager with Voltage
7.6.1 Supplying the SunnyHomeManager with Voltage via the
Plug-In Power Supply Unit
Danger to life due to electric shock
Under fault conditions, when working on the power supply circuit there may be dangerous
voltages present on the Sunny Home Manager.
• Ensure that the outlet for the power supply unit is close to the power supply unit. This
ensures that you can safely disconnect the SunnyHomeManager from the voltage supply.
• The outlet for the power supply unit must be freely accessible at all times.
Risk of fire due to connecting two power supply units
If two power supply units are connected to the SunnyHomeManager, the requirements on
current sources with limited output will be exceeded. This can result in the SunnyHomeManager
overheating.
• Only connect one power supply unit to the SunnyHomeManager.
1. Connect the DC plug of the plug-in power supply unit to the Power pin connector of the
SunnyHomeManager.
2. Plug the plug-in power supply unit into the outlet.
☑ The status LED of the SunnyHomeManager first is glowing red, and then is flashing red.
After approximately two minutes, the status LED intermittently is flashing green and
orange. The SunnyHomeManager is connected to SunnyPortal.
✖ The status LED is not intermittently flashing green and orange?
It is possible that the SunnyHomeManager is not correctly connected to the router.
• Ensure that the SunnyHomeManager is correctly connected to the router (see
Section7.4, page47).
7 Connection
SMA Solar Technology AG
Installation ManualHoMan-IA-en-2048