SMA sunny home manager - Data Collection for Sockets; Assigning Loads to Sockets

Procedure:
• Press the reset button with a sharp object (e.g.
paper clip) and hold until the desired reset
result has been achieved:
• To reset the network settings of the SunnyHomeManager, press the reset button until
the status LED and the energy consumption LED are intermittently flashing orange.
• To completely reset the SunnyHomeManager, press the reset button until the status LED
and the energy consumption LED are intermittently flashing red.
10.7 Reassigning the SunnyHomeManager to the
SunnyPortal System after the Reset
If you have performed a complete reset of the SunnyHomeManager (see Section10.6,
page75)), you must reassign the SunnyHomeManager to your SunnyHomeManager system in
SunnyPortal. Otherwise, SunnyPortal will not accept any data from the SunnyHomeManager.
You have the following options for reassigning the SunnyHomeManager to your
SunnyHomeManager system:
• Reassigning the SunnyHomeManager via the PV System Setup Assistant
or
• Reassigning the SunnyHomeManager via the SunnyPortal access (see the user manual
"SunnyHomeManager in SunnyPortal")
Reassigning the SunnyHomeManager to the SunnyHomeManager System
via the PV System Setup Assistant
Requirement:
☐ You must be the PV system administrator (for user roles and user rights, see the user
manual "SunnyHomeManager in SunnyPortal").
Procedure:
1. Open www.SunnyPortal.com and select [PV System Setup Assistant].
or
Go to www.SunnyPortal.com/Register.
☑ The PVSystem Setup Assistant opens.
10 Troubleshooting
SMA Solar Technology AG
Installation ManualHoMan-IA-en-2076