SMA sunny home manager - Setting Socket Operating Modes

2. Select [Next].
☑ The page User registration opens.
3. Activate the checkbox I am already registered in SunnyPortal.
4. Enter the e-mail address and the SunnyPortal password in the fields E-mail address and
Password.
5. Select [Next].
☑ The page Select PV system opens.
6. Activate the field Add or replace devices.
7. In the line of the SunnyHomeManager system to which you would like to reassign the
SunnyHomeManager, select .
8. Select [Next].
☑ The page Select devices opens.
9. Enter the serial number of the SunnyHomeManager in the field PIC. Enter the registration ID
of the SunnyHomeManager in the field RID.
10.
Reading off the serial number and registration ID
You can read off the serial number and the registration ID from the type label on the rear
of the SunnyHomeManager.
11. Select [Identify].
☑ SunnyPortal checks whether the serial number and registration ID correspond to the
connected SunnyHomeManager.
✖ The PVSystem Setup Assistant cannot find any SunnyHomeManager with the serial
number and registration ID?
An error has occurred.
• Eliminate the error (see Section10 "Troubleshooting", page62).
12. Select [Next].
13. Select [Finish].
10.8 Resetting the SMARadio-ControlledSocket to Default
Settings
You must reset the SMAradio-controlled socket to default settings in the following cases:
• You wish to operate the SMAradio-controlled socket in a different system.
• You wish to reset the measured values of the SMAradio-controlled socket.
10 Troubleshooting
SMA Solar Technology AG
Installation Manual 77HoMan-IA-en-20